SIPA SFR 6 infrared lamp bulb

Thu, 25 Jun 2026 06:47:59 +0800

On the blow molding line, preform heating is where you win stability—or lose it. A sloppy heat profile makes you chase every bottle, and a thermal field that drifts shows up fast: crystallization, wall thickness swings, and jams. The SIPA SFR 6 infrared lamp is built to put your heating performance back where it should be—so you can run the same cycle, the same preform, and the same quality, shift after shift. What matters, technically The SFR 6 is a short-wave infrared emitter, built around a quartz tube and a halogen filament matched to the system. It responds quickly and holds output steady. Power and voltage are matched to the SIPA SFR heating module, so it drops in without rewiring or second-guessing. You get a repeatable temperature rise that tracks the preform’s thermal curve, with controlled penetration into the wall and base. The lamp’s geometry and mounting keep the reflector path aligned, so the thermal field stays even across the heating tunnel—fewer hot and cold bands. Why this matters on a stretch blow molder Stretch blow molding lives and dies by a narrow heating window, and there’s little room for drift. With the SFR 6, you hit steady state faster, avoid temperature overshoot, and keep preform conditioning consistent. That means fewer rejects from incomplete stretch, less brittleness, and less downtime spent retuning heat. Energy use drops, too, because the lamp hits setpoint quickly and holds it without chasing it with repeated high-power recovery cycles. The practical details you need This bulb is a direct fit for SIPA SFR machines, but still confirm lamp length, wattage, and connector type against your exact model and heating zone layout. Infrared emitters are sensitive—keep the lamp surface and reflectors clean. Grease, dust, and oxidation scatter heat and throw your profile off. If you run the lamp above its rated voltage or cycle it on/off too often, expect a shorter life. Schedule replacements during planned maintenance, and after installation, always double-check lamp alignment and reflector geometry.

SFR on Infrared Element Systems

SIPA SFR 6 infrared lamp bulb